Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Cooling systems, heating
4.1. Specifications
4.2. Antifreeze
4.3. Thermostat
4.4. Fan and relay of turning on of the fan
4.5. Radiator and broad tank
4.6. Pump of cooling liquid
4.7. Sensor of temperature of cooling liquid
4.8. Fan block
4.9. Heater radiator
+ 4.10. Control panel of a heater and conditioner
4.11. Vlagootodelitel of the conditioner
4.12. Compressor
4.13. Condenser
4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Depressurize the conditioner and remove coolant in service of Toyota car service or in a specialized workshop. |
| 2. Disconnect the battery from weight. |
| 3. Take off from the compressor a belt (see subsection 2.6.4). |
|
4. Disconnect the conducting socket (it is specified by a big arrow) from the compressor, turn off bolts of flange connections (two small arrows) and disconnect coolant tubes from the compressor. |
|
5. Turn off bolts of fastening of the compressor (shooters specified two lower bolts, two more bolts are in the top part of the compressor) and remove the compressor. |
| 6. If the new compressor is installed, then perform all procedures specified in the enclosed instruction. Before installation check oil level in the compressor. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down. Replace laying, specially prednazanachenny it is concrete for type of your compressor, oil laying, recommended for your conditioner. |
| 2. Fill the conditioner with coolant in the same workshop in which depressurization and removal of coolant were carried out. |
|
|
|
